GPS positioning signals and aircraft movements displayed:

Installation location is:

Requirements:

1. Receive direct sunlight, therefore, require high temperature, good heat dissipation;
2. Size does not affect the driver's line of sight: 6.4 ~ 10 inch screen, the size of 30cm in length;
3. AWS workstation install cabinets for the 48-volt DC power supply; equipped with GPS positioning system, signal acquisition, and through serial or Ethernet ways 1 ~ 2 of the GPS data transmitted to the TPC.
4. TPC's role:
   • Show GPS location information
   • Through 2-D animation shows the aircraft in the operating position of the region;

Software Analysis:

1. GPS signal transmission through the 485 or Ethernet without difficulty;
2. How to screen for dynamic display? Some may be more difficult.
3. Customers off-the-shelf Windows platform in the development of the project, if the ability to easily migrate to the TPC of the problem can be resolved quickly.

Program:

1. The use of TPC064, WinCE system, the customer development process through the EVC by 485 or Ethernet transmission GPS signal analysis: Customer original complex transplant procedures
2. The use of TPC064, WinCE system, the customer through the configuration software development, to facilitate communications solutions, however, demonstrates the difficulties and animation.
   Analysis: the rapid development of customer, but the animation shows the problem.
3. UNO and the touch screen through the way of touch, display and controller separation, such as better. ELO if the LCD display + UNO2170 + HMIBuilder software

863 aerogeophysical remote sensing project

Carried out through the extraction of remote sensing technology prospecting the market anomaly

Through aerogeophysical (electric, magnetic) Integrated stand known Cu-Mo polymetallic deposits on the flight measurements, based on the principle known to the unknown, the establishment of aerogeophysical (electric, magnetic) Integrated Measurement in grassland, forest, marsh area search for porphyry copper-polymetallic ore prospecting model. According to this test model aerogeophysical anomalies delineated, in the ground to get a good check of the geological effects.

New features:

1. Including wing aircraft, including around the emission source as a remote sensing; fired power 500,000 amps / m ² large signal: 2.2GHz
2. 80m from the receiver aircraft following the completion of the pod on, less interference;
3. Sync method: signal synchronization, GPS has always been synchronized
4. Machine workstations, analog-to-digital processing to do.

Selection requirements:

1. Workstation machine: I hope that the use of higher speed, AD conversion of the system higher.
   Customers want to choose products MIC3000.
2. Pod hope for the treatment plant, and analog-to-digital conversion, collection and storage, we recommend to deal with UNO
3. ADC performance requirements:
   1. Large dynamic range
   2. 24-bit resolution
   3. Ceiling can be controlled
   4. High-speed, acquisition speed 60K, processing speed of at least 30K
   5. Channel 3
4. Send pulse needs: 25Hz is equivalent to a 40ms cycle, 20ms2 pulses. Need to channel 3.

Process requirements:

1. Machine workstations, not only to receive all the aircraft's flight information at the same time, responsible for sending pulses;
2. Through the pod receiving device, receiving signals reflected from the earth.
3. Transmit pulse and receive pulse to be consistent.
4. The photo shows the work of the next diagram: